Hook with a tab to create a pile, for work you will need cut threads 2 times long
greater than the desired pile length. Instructions for use:
From the front of the mat backing, insert the hook to the beginning of the tongue, with the tongue open and the thread under the warp.
Catch the yarn by crocheting, lower the hook so that the tongue goes all the way through the warp.
Pull the hook up, the tongue will drop and close, the thread will be inside a hole was created.
Pull the thread to the right side of the warp to a height of about 0.5-1 cm, this is loop #1.
Leaving loop #1 on hook, insert hook into adjacent warp square to form loop #2, while loop #1 should remain on the front of the base above the open tongue.
Repeat steps 1-3 to form loop #2.
Pull clip #2 inside hole #1 so that the thread ends are on the right side of the warp.
Tighten the knot by hand.